Table of Contents
Advertisement
Programming of "Agility"
The.programming.of."Agility".is.available.if.you.are.using.the."user".flight.mode.(see.the.section."Setting.the.flight.mode").and.you.are.using.
a.remote.control.with.five.channel.or.above..If.you.are.using.a.remote.control.with.only.four.channel,.or.you.do.not.want.to.use.the.function,.
the.programming.will.be.ended.in.five.seconds..If.the."Agility".is.not.programmed.in.the.five.seconds,.the.function.is.disabled.and.cannot.be.
used.during.flight..
1.
Switch a switch on your remote control to on position, and then switch it to off again.
2.
The switch is at the off position when the programming of the function is completed. This function can be turned on or off by the switch
during.a.flight.operation.
3.
As.confirmation,.the.green.LED.(LD1).lights.up..
Do not disconnect the rechargeable battery before the green LED (LD1) lights up. The settings will not be saved.
4.
Disconnect.the.rechargeable.battery.from.the.RC.EYE.650.and.switch.off.the.DIP.4.(away.from.ON.position).
5.
This is the end of the programming process for the channels.
Possible flight modes
Mode
Throttle
1
2
3
4
Setting the flight mode
The.RC.EYE.650.offers.three.different.flight.modes.
>
Beginner (suitable for novices)
>
Sport.(suitable.for.proficient.RC.EYE.650.pilots;.lower.axis.limits.and.higher.dynamics)
>
User.(flight.parameters.adjustable.with.a.optionally.available.configuration.PC.software)
The.flight.mode.is.configured.before.switch-on.by.setting.the.DIP.switches.and.cannot.be.altered.during.operation..The.positions.for.the.
switches.are.on.the.combined.flight.control.board.(QC-09.&.QC-07).
Yaw
Nick
Roll
P. 27
Advertisement
Table of Contents
