Table of Contents
Advertisement
Ensure before each operation that the propellers are firmly screwed in place on the motors. Be careful when handling work
tools.
6.
Put.a.cap.cover.(Box.2-e).at.the.bottom.of.the.aluminium.profile..Insert.the.joint.first,.then.flip.it.up.to.lock.the.position.
9.
ConfIgurAtIon
general Information
Carry.out.the.configuration.of.the.RC.EYE.650.as.described.in.this.chapter..Programming.of.the.channels.is.essential,.since.otherwise.the.
RC.EYE.650.will.not.recognise.your.transmitting.equipment..When.you.have.done.this,.your.RC.EYE.650.is.ready.to.fly..
If you are using a computer remote control, programme it without using a mixer in the standard program.
To.correctly.align.the.pilot.stick.for.the.desired.control.commands,.it.is.necessary.to.programme.the.RC.EYE.650.with.the.transmitter.used..
In.the.process,.the.RC.EYE.650's.electronics.system.memorises.the.channel.on.which.each.control.command.is.broadcast..Generally,.
you.can.freely.choose.the.configuration.of.the.control.lever.(according.to.your.use),.however,.it.is.recommended.that.beginners.follow.the.
recommended examples.
Ex-factory,.the.RC.EYE.650.is.configured.to."mode.2"..The.examples.are.for.a.common.assignment.used.by.many.model.pilots..
Decide.which.configuration.you.wish.to.programme.and.programme.the.channels.correspondingly..Further.possibilities.for.control.modes.1,.
3.or.4.(modes.1,.3.or.4).can.be.found.in.the.instructions.in.this.chapter.under.the.heading."Possible.Flight.Modes"..
For.monitoring.the.configuration.and.indicating.the.malfunction.or.operating.status,.a.red.and.a.green.LED.(LD1).are.installed.on.the.control.
board..The.respective.indications.can.be.seen.in.the.table.in.the.following.chapter."safety.devices".in.this.instruction.manual..
When using multiplex remote controls, the servo protocols must be adapted for all four functions (throttle, roll, nick and
yaw) from "MPx" to "unI".
If the rC eye 650 cannot be programmed onto your remote control, this may be due to the reverse function of your remote
control. We recommend pressing the reverse switch for the throttle function and retrying programming.
P. 24
2
1
Advertisement
Table of Contents
