Table of Contents
Advertisement
Beginners in particular are urgently advised to reduce the directness of the control command with whichthe RC EYE 650 performs
the commands from the remote control around the centre detent (negativeexponential "expo").
Normally,.the.RC.EYE.650.responds.linearly..This.means.that.the.pilot.stick.deflection.and.the.reaction are synchronous. With negative
expo,.the.RC.EYE.650.will.respond.relatively.sluggishly.at.the.start.of.the.controlling.motion..In.the.case.of.stronger.control.deflections,.
however,.it.responds.much.more.strongly.to.the.control.command..This.is.particularly.beneficial.for.beginners.who.initially.tend.to.oversteer,.
i.e..move.the.control.stick.of.the.remote.control.more.intensely.than.necessary..This.effect.is,.of.course,.only.desired.for.the.three.control.
axes.(roll,.nick.and.yaw).and.not,.however,.for.throttle..Thus:.Do.not.configure.expo.on.the.throttle!.In.other.words:.With.negative.expo,.slow.
behavior.of.the.flying.device.is.achieved.on.the.controlling.motions.in.the.area.of.the.centre.detent.of.the.pilot.stick..This.takes.place.either.
via.the.optionally.available.software,.via.the.RC.EYE.650's.jumpers.(see."beginner.mode").or.via.the.existing."expo.function".of.the.remote.
control..Only.computerised.remote.controls.can.set."expo"..However,.care.must.be.taken,.since.the.higher.the.negative.expo.selected,.the.
more.aggressively.the.RC.EYE.650.reacts.when.the.control.stick.is.moved.in.the.area.of.full.deflection.
To.set.the.modes:
>
Beginner.-.Switch.off.DIP.1.and.2.
>
Sport.-.Switch.on.DIP.1.and.switch.off.DIP.2.
>
User.-.Switch.off.DIP.1.and.switch.on.DIP.2.
For the "user" flight mode, you must configure your own setting with the optionally available configuration PC software. The default
setting of the "user" flight mode is the same as the "beginner" flight mode. Observe the operating instructions for the software.
The software can be purchased separately: 89002RC Configuration Kit.
10.
PreflIght PrePArAtIon
Checking the Connections
Check.all.screws.for.tightness.before.transport.and.flights..Vibration.during.transport.and.flight.may.cause.screws.to.loosen..Due.to.this,.you.
need.to.conduct.a.thorough.pre-flight.check.just.as.for.a.real.helicopter.
Checking Movable Parts
Always.check.all.movable.parts.and.all.parts.with.bearings.for.unobstructed.movement.before.flying..They.must.be.easy.to.move,.but.without.play.
Adjustment of the neutral Position
For the stabilisation.of.the.RC.EYE.650.to.work.correctly,.the.neutral.position.must.be.set..This.is.the.position.that.the.RC.EYE.650.tries.to.
stabilise.as.long.as.no.other.flying.manoeuvre.is.desired.
Proceed.in.the.following.sequence:
1.
Switch on the transmitter.
2.
Set THROTTLE to zero and all other levers and trims to the neutral position.
3.
Place.the.RC.EYE.650.on.a.level,.even.surface!
Use the enclosed spirit level (Box 4-i) to check the level of the surface.
4.
Connect.the.rechargeable.battery.to.the.RC.EYE.650.
5.
The.RC.EYE.650's.red.LED.(LD2).must.be.OFF.and.the.green.LED.(LD1).must.be.ON.
6.
Move.THROTTLE.to.full.deflection.and.YAW.to.full.deflection.on.the.right.
P. 28
Advertisement
Table of Contents
