Table of Contents
Advertisement
option 1: using the rubber ring
1.
Insert.the.rubber.rings.(Box.4-c).into.the.holes.of.the.landing.gears.
2.
Remove.the.cap.from.a.carbon.fibre.(Box.4-b).
3.
Observe.the.orientation.of.the.RC.EYE.650..Pass.a.yellow.silicon.tube.(Box.4-d).through.the.carbon.fibre,.then.pass.the.carbon.fibre.through.the.
hole at the bottom of a rear landing gear.
4.
Pass.the.carbon.fibre.through.the.hole.at.the.bottom.of.the.closest.front.landing.gear.
5.
Pass.the.red.silicon.tube.(Box.4-e).through.the.carbon.fibre.
6.
Place.the.cap.back.on.the.carbon.fibre..Repeat.the.above.five.steps.for.the.other.carbon.fibre.and.the.remaining.landing.gears.
option 2: using the landing protection rubber
1.
Remove.a.cap.from.one.end.of.a.carbon.fibre.
2.
Insert.a.landing.gear.into.a.landing.protection.rubber.(Box.4-h)..Observe.the.correct.orientation.
3.
Observe.the.orientation.of.the.RC.EYE.650..Pass.a.yellow.silicon.tube.through.the.carbon.fibre,.then.pass.the.carbon.fibre.through.the.rear.
landing gear and the landing protection rubber.
4.
Replace the cap.
5.
Remove.the.cap.from.the.other.end.of.the.carbon.fibre.
6.
Insert the closest front landing gear into another landing protection rubber. Observe the correct orientation.
7.
Pass.the.carbon.fibre.through.the.front.landing.gear.and.the.landing.protection.rubber,.then.pass.the.red.silicon.tube.through.the.carbon.fibre.
8.
Place.the.cap.back.on.the.carbon.fibre..Repeat.the.above.five.steps.for.the.other.carbon.fibre.and.the.remaining.landing.gears.
P. 18
2
3
Advertisement
Table of Contents
