Safety Instructions - RC Logger 88001RC Operating Instructions Manual

Table of Contents

Advertisement

The.following.components.not.included.in.delivery.are.required.for.assembly.and.operation:
Assembly:
Soldering.iron.and.the.necessary.kit..Tools.for.assembly.models,.such.as.hand.drills,.needle-nose.pliers.and.screwdrivers.
operation:
To.operate.the.model,.a.simple.6.channel.remote.control.system,.a.3-cell.LiPo.flight.battery.with.a.minimum.capacity.of.3600.mAh.and.a.
discharge.rate.of.30.C,.as.well.as.a.compatible.LiPo.charging.device.with.LiPo.balance.charger.are.required.
See the chapter RECOMMENDED ACCESSORIES for tried and tested accessories.
4.

sAfety InstruCtIons

read the operating instructions carefully and especially observe the safety information. If you do not follow the safety
instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or
damage to property. such cases will invalidate the warranty/guarantee.
operating the model may cause damage to property and/or persons. therefore, make sure that you are properly insured
when using the model, e.g. by taking out private liability insurance. If you already have private liability insurance, inquire
about whether the operation of the model is covered before operating it. Please note: In some eu countries, you are
required to have insurance for any flying models!
Persons / Product
>
The device is not a toy. Keep it out of the reach of children and pets.
>
Do.not.leave.packaging.materials.lying.around.carelessly..They.can.be.dangerous.if.played.with.by.children.
>
Protect.the.product.from.extreme.temperatures,.direct.sunlight,.strong.jolts,.high.humidity,.moisture,.flammable.gases,.vapours.and.
solvents.
>
Do not place the product under any mechanical stress.
>
If.it.is.no.longer.possible.to.operate.the.product.safely,.take.it.out.of.operation.and.protect.it.from.any.accidental.use..Safe.operation.can.
no.longer.be.guaranteed.if.the.product:
-
is visibly damaged,
-
is.no.longer.working.properly,.
-
has been stored for extended periods in poor ambient conditions or
-
has.been.subjected.to.any.serious.transport-related.stresses.
>
Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
>
Also observe the safety and operating instructions of any other devices which are connected to the product.
>
If.you.do.not.have.sufficient.knowledge.yet.of.how.to.fly.remote-controlled.helicopters,.please.contact.an.experienced.model.sportsman.
or.a.model.construction.club..Alternatively,.it.is.recommended.that.you.practice.on.a.suitable.flight.simulator.before.first.use.
Before operation
>
Regularly.check.the.functional.safety.of.your.model.and.of.the.remote.control.system..Watch.out.for.visible.damage.such.as.defective.
plug connections or damaged cables.
>
All moving parts of the model must run smoothly, but should not have any play in their bearings.
>
Check.before.each.operation.the.correct.and.secure.position.of.the.propellers.
>
Charge.the.flight.battery,.which.is.necessary.for.operation,.as.well.as.the.rechargeable.battery.that.may.be.inserted.in.the.remote.control.
according the manufacturer's instructions.
>
If.batteries.are.used.as.a.transmitter.power.supply,.make.sure.that.they.have.sufficient.remaining.capacity.(battery.checker)..If.the.
batteries are empty, always replace the complete set, never individual cells only.
>
Always.switch.on.the.transmitter.first..Please.ensure.that.when.you.turn.on.the.transmitter.the.throttle.control.is.set.to.the.lowest.setting.
(motors.off)!.Then.the.flight.battery.of.the.model.may.be.connected..Otherwise,.unexpected.reactions.of.the.model.may.occur.and.the.
propellers might run unintentionally!
>
When.the.propellers.are.running,.make.sure.that.neither.objects.nor.body.parts.are.in.the.rotating.and.suction.area.of.the.propellers.
P. 8

Advertisement

Table of Contents
loading

Table of Contents