Table of Contents
Advertisement
6.
Observe.the.correct.orientation;.there.is.a.hole.for.the.antenna.on.the.left.side.of.the.RC.EYE.650..Place.the.stabilizer.on.the.top.body.
frame,.fasten.it.at.the.corner.with.four.screws.for.the.stabilizer(ø2.8.x.15.mm,.silver).(Box.3-g-I)).and.wave.washers.for.the.stabilizer.
(Box.3-g-II)..
7.
Bind.the.stabilizer.with.the.aluminium.profiles.with.the.magic.tape.for.the.stabilizer,.150.x.20.mm.(Box.3-h-I)..The.red.one.(Box.3-h-II).is.
for.identifying.the.front.of.the.RC.EYE.650.
Connection of the receiver
1.
Connect the other end of the 10-pin.flat.cable.respectively.to.the.receiver..The.contacts.are.assigned.as.follows:
Contact 1 = Channel 1
Contact 2 = Channel 2
Contact 3 = Channel 3
Contact 4 = Channel 4
Contact 5 = Channel 5
Contact 6 = Channel 6
Contact 7 = Channel 7
Contact 8 = Channel 8
Contact.9.=.Ground./.Negative.(–)
Contact.10.=.5.V./.Positive.(+)
The.signals.of.the.8.inputs.(channels.1.–.8).are.measured.and.processed.by.the.composite.signal.converter..All.available.signals.are.
combined.into.a.composite.signal.pursuant.to.the.specifications.for.RC.remote.control.systems.(pulse.width.between.1.and.2.ms)..Due.
to measuring of the signals and signal processing, there will be a delay of one frame length. However, this has no effect during operation
and.is.therefore.only.mentioned.for.the.sake.of.completeness..
The.measured.servo.signals.may.appear.in.any.order,.parallel,.in.sequence.or.overlapping..There.is.no.limitation,.so.that.the.composite.
signal.converter.can.be.used.for.all.common.systems..A.sync.break.between.the.different.signals.is.also.not.required..
For the receiver's power supply, it is sufficient to connect the contacts 1 (negative / –) and 2 (positive / +) to a single servo
connection cable.
P. 20
1 2 3 4 5 6 7 8 9 10
R9 R13
R10 R14
ST2
C6
5
C1
6
R3 R7 R11 R15
ST3
ST1
1
2
Advertisement
Table of Contents
