Table of Contents
Advertisement
4.
Loosen.the.screws.of.the.motor.clamp.and.remove.the.motor.from.the.motor.clamp..Pull.the.cable.through.the.aluminium.profile.
5.
Take.the.new.motor.and.pull.the.connecting.cable.through.the.aluminium.profile.
6.
Either solder the new wires to the male bullet connectors of the old wires (you need to cut out the bullet connectors, and connect the
wires following the colours) and reconnect the wires to the motor driver board or directly solder the new wires to the motor driver board
directly.(you.need.to.desolder.the.old.wires.and.mark.down.the.respective.colour.of.the.solder.point).
If the colours of the connecting cables are swapped, the rotating direction of the motors will change. this will cause the
model to malfunction. As a precaution, compare the configuration of the other motors with that of the replaced motor.
Loss of guarantee/warranty!
7.
Insert.the.driver.board.in.its.slot.once.again;.check.to.see.if.the.cables.are.lying.correctly.and.the.PCBs.have.been.inserted.to.the.slots.
accordingly.
8.
Replace.the.top.body.frame,.stabilizer.and.canopy.as.described.in.the.chapter."ASSEMBLY".
9.
Cover the top body frame with the canopy and fasten it with the rubber band.
10.
Should you wish to replace several motors, you should carry out the individual steps for each motor.
Replacing an aluminium profile
Damaged.aluminium.profile.can.be.replaced..
1.
Remove the spinner, wave washer and propeller from the faulty motor.
2.
Remove the canopy.
3.
Remove the stabilizer and the top body frame by loosening the screws. Now you have free access to the motor driver board. Detach the
bullet connector from the faulty motor.
4.
Loosen.the.screws.of.the.motor.clamp.and.remove.the.motor.from.the.motor.clamp..Pull.the.cable.through.the.aluminium.profile.
5.
Secure.the.motor.to.the.new.aluminium.profile.
6.
Follow.the.steps.in."ASSEMBLY.>.Attaching.aluminium.profiles".to.install.the.new.aluminium.profile.onto.the.bottom.body.frame.
7.
Reconnect the bullet connectors to connect the wires of the same colour.
8.
Replace.the.top.body.frame,.stabilizer.and.canopy.as.described.in.the.chapter."ASSEMBLY"
9.
Should.you.wish.to.replace.several.aluminium.profiles,.you.should.carry.out.the.individual.steps.for.each.motor.
replace the body frame
If.the.body.frames.(top.and.bottom.body.frames).are.broken.after.crashing.but.the.PCBs.are.still.in.working.condition,.it.is.possible.to.replace.
the complete frame.
1.
For this, simply remove the canopy, stabilizer, top body frame chassis and landing gear.
2.
Detach bullet connectors.
3.
Detach.the.aluminium.profiles.with.the.motors.from.the.body.frame.
4.
Now pull the PCBs from the slot and put in the new bottom body frame.
5.
Assemble the chassis and the landing gear.
6.
Mount.the.aluminium.profiles.in.the.new.bottom.body.frame..
7.
Replace.the.top.body.frame,.stabilizer.and.canopy.as.described.in.the.chapter."ASSEMBLY"..If the stabiliser plate is damaged, it can be
replaced.
The spare parts list is located on our Internet page www.rclogger.com in the download section for the
respective product.
P. 35
Advertisement
Table of Contents
