Table of Contents
Advertisement
POWER SAVE
The <
> key lights up while in the mode.
Memo
By factory default, the time interval to enter the power
saving mode is set to 1 minute. You can change the time
interval by pressing the <SETTING> key on the operator
panel and selecting [Admin Setup] > [Management] >
[Power Save] > [Power Save Time].
Sleep Mode
Your machine goes from the power saving mode
into the sleep mode after a set period of time. In
the sleep mode, the status of your machine is
almost the same as when it is turned off.
The <POWER SAVE> key blinks while in the
sleep mode.
Note
The machine does not enter the sleep mode if an error
occurs.
If time-set transmission is scheduled, the machine will not
go into sleep mode.
If the fax transmission is waiting for a redial, the machine
cannot enter sleep mode.
Memo
By factory default, the time interval to enter the sleep
mode is set to 30 minutes. You can change the time
interval by pressing the <SETTING> key on the operator
panel and then selecting [Admin Setup] >
[Management] > [Power Save] > [Sleep Time].
Returning to the Standby Mode
To return the machine to the standby mode from
the power saving or sleep modes, press the
<POWER SAVE> key on the operator panel.
Memo
When your machine receives a print job from a computer
or other devices, it automatically returns to the standby
mode.
Auto Power Off
When your machine is not used for a certain
period of time, the power turns off automatically.
Once the machine turns off, you need to turn on
to use it.
The machine has three settings to select the
machine's behavior on Auto Power Off.
Enable
Auto Config
Disable
Enable
When your machine is not used for a certain
period of time, it turns off the power
automatically.
Auto Config
The machine will not turn off automatically under
the conditions listed below.
- An Ethernet cable is attached to network
interface connection
- A telephone cable is attached to LINE
connection
Disable
The Auto Power Off function is disabled. The
machine will not turn off automatically.
Note
In the following cases, the Auto Power Off function is also
disabled.
- When an error occurs
- When time-set transmission is scheduled
- When the fax transmission is waiting for a redial
- When [Auto Power Off] is [Auto Config.] and
Ethernet cable is attached
- When [Auto Power Off] is [Auto Config.] and
telephone cable is attached
Memo
By factory default, the time interval to turn off the power
is set to 4 hours. You can change the time interval by
pressing the <SETTING> key on the operator panel and
then selecting [Admin Setup] > [Management] >
[Power Save] > [Auto Power Off Time].
By factory default, [Auto Power Off] is set to [Auto
Config]. You can change the setting by pressing the
<SETTING> key on the operator panel and then selecting
[Admin Setup] > [User Install] > [Power Save] >
[Auto Power Off]
- 25 -
Installing Your Machine
1
Advertisement
Table of Contents
