Table of Contents
Advertisement
Error
code
Please change File Name.
Please see Help for details.
to close
OK
Device communication protocol not
supported.
Please see Help for details.
to close
OK
Please check Network Share Name.
Please see Help for details.
to close
OK
Please remove the connected USB
device.
Unsupported USB device is
connected.
Please remove the USB Hub.
USB Hub is connected.
Access denied to PC.
Please check PC.
to Close
OK
Error Messages for Printing
Error
code
Offline Mode
Error Postscript
to close
OK
PDF Cache Write Error
to close
OK
Message
Message
<Status>
key
Blinks
A file name was not authorized by the server.
Change the file name.
If using an FTP server to save data with Scan
to Network PC, there are some machines that
cannot be connected correctly due to
mismatching character codes. Change [Host
side Japanese Kanji code]. If using a Mac for
the FTP server, change [Host side Japanese
Kanji code] to [UTF-8].
Blinks
The machine does not support the specified
server.
If using NAS to save data with Scan to Network
PC, in rare cases there are machines that cannot
connect correctly with CIFS. Change the profile
[CIFS Character Set] to [Shift-JIS] from
[UTF-16].
Blinks
The name of a network shared folder is invalid.
The machine failed to establish a CIFS
connection.
Change the name of the shared folder.
Blinks
Indicates that an unsupported USB device has
been connected.
This message will be displayed until the
unsupported USB device disconnected.
Blinks
A USB hub has been connected. This machine
does not support the USB hub.
Disconnect the USB hub.
Lights up
The PushScan request has been rejected by the
PC.
<Status>
key
Lights up
The machine is off line and cannot start a print
job.
Press the <PRINT> key on the operator panel
and then select [Online/Offline] on the print
menu screen.
Lights up
A Postscript error has occurred.
Lights up
Writing failed while caching a PDF, as there was
no space on the SD card or memory.
Increase the amount of free capacity on the SD
memory card. (e-STUDIO403S only).
Increase the amount of memory (for cases
other than e-STUDIO403S).
- 143 -
Error Messages
Cause/Remedy
Cause/Remedy
7
Advertisement
Table of Contents
