Replacing The Image Drum - Toshiba e-Studio332s Operator's Manual

Replacing Consumable Items
Note
Do not use solvents, such as methyl alcohol or thinners.
They damage the LED head.
Close the top cover.
4
Close the scanner unit.
5
Memo
If you dispose of a toner cartridge by necessity, put it in a
polyethylene bag or something and then dispose of it in
accordance with your municipality's ordinances or guidelines.

Replacing the Image Drum

Life Duration of Image Drum
When the [Image Drum Near Life] message
appears on the display screen, prepare a
replacement image drum.
If you continue printing, the message [Please
Replace the Image Drum] will be displayed
and printing will stop.
A guideline for replacing the image drum is every
30,000 pages or so for A4 sized paper (with
single-sided printing). However, this number of
pages is for printing with general conditions (3
pages at a time). Printing one page at a time
reduces the drum life by about half.
The actual number of printed pages may be
halved again relative to the above guideline,
depending on the printing conditions.
Note
The actual number of pages you can print with the image
drum depends on how you use it. The above guideline may be
reduced by more than half, depending on the conditions of
printing.
Note
The print quality may deteriorate after the toner cartridge
has been unpacked for a year. Replace it with a new one.
Procedure for Replacement
Note
The image drum (the green tube) is very delicate. Handle
it carefully.
Do not expose the image drum to direct sunlight or very
bright interior light (approximately more than 1500lux).
Even under the normal interior light, do not leave it for
more than 5 minutes.
To ensure optimum performance, please use original
TOSHIBA consumables.
Service for problems caused by the use of consumable
items other than genuine TOSHIBA consumables is not
covered under the warranty or in the maintenance
contract. (This does not apply to all faults occurring with
non-original TOSHIBA products; however, please bear this
in mind when using them.)
Open the top cover and remove the used
1
image drum.
Remove the image drum upward slowly.
If the image drum is removed, the toner
cartridge is also removed.
Memo
When making duplex copies using the document glass, the
continuous scan mode is automatically enabled. Follow the
on-screen instructions.
WARNING
Install a new image drum.
2
Take the new image drum out of the wrapping
bag. Remove the silica gel.
Silica gel
Note
Always use a new image drum. An image drum that has
been attached or used on another printer cannot be used.
- 166 -
Be sure not to throw used image
drum and toner cartridges into
fire; toner in the cartridges may
scatter and ignite, causing burn
injuries.