Power Saving Mode; Sleep Mode - Toshiba e-studio222cs User Manual

P
OWER SAVING MODE
If you do not use the machine for a while, it will enter power saving mode to control the
power consumption of the device. To cancel or initiate power saving mode, press the
Power Save button on the control panel.
NOTE
If your machine is connected locally (via USB), when it transitions to Sleep
mode its status is viewed as off-line. To use the printer in this state, you must
press the Power Save button to exit sleep mode.
By default, the time interval to enter the power saving mode is set to 30
minutes. Refer to
You can enable or disable the power saving mode. Refer to
Enable" on page
S
LEEP MODE
Your machine transitions from power saving mode to sleep mode after a set period of time.
In sleep mode the power consumption of the device in minimal. To cancel or initiate sleep
mode, press the Power Save button on the control panel.
NOTE
The machine will not enter sleep mode if an error occurs and the machine
requires attention.
By default, the time interval to enter sleep mode is set to 10 minutes. Refer
to "Sleep Time" on page
You can enable or disable sleep mode. Refer to
"Power Save Time" on page
163.
162.
Getting started > 20
162.
"Power Save
"Sleep" on page 163.