Motor Specifications And Electrical Requirements - Power Fist SS13W Owner's Manual

5. Do not abuse the cord. Never use the cord to pull the tool or pull the plug from an outlet. Keep cord
away from heat, oil, sharp edges or moving parts. Do not operate this tool if the power cord is frayed or
damaged. Replace damaged cords immediately. Damaged cords increase the risk of electric shock. Do
not modify the plug in any way.
6. When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W". These
cords are rated for outdoor use and reduce the risk of electric shock.
7. Avoid using an unnecessarily long extension cord. Choose a cord that is appropriate for the situation,
as a cord that is too long and running across the floor can be more dangerous than helpful.
8. Problems concerned with any moving part(s) or accessories must be investigated and corrected with
the power disconnected and after everything has come to a complete stop.
9. Never leave tool running unnattended
Turn power off. Don't leave tool until it comes to a complete stop. Safety is a combination of operator
common sense and alertness at all times, when the scroll saw is being used.
10. Never stand on a tool
Serious injury could occur if the tool is tipped or if the cutting tool is accidentally contacted. Do not store
materials above or near the tool such that it is necessary to stand on the tool to reach them.
UNPACKING
CAUTION: NEVER LIFT THIS SAW BY THE ARM which holds the blade or damage will occur
to your saw.
1. Carefully remove the parts and accessories from the box.
2. Make sure that all items listed in the packaging lists are included.
3. Inspect the parts carefully to make sure no breakage or damage occurred during shipping.
4. Do not discard the packaging material until you have carefully inspected and satisfactorily
operated the tool.
WARNING! For your own safety, DO NOT ATTEMPT TO OPERATE your scroll saw until it is
completely assembled and installed according to the instructions. If any part is missing,
do not operate the tool until the missing parts are replaced. Failure to do so could result in
serious personal injury.
# Parts list
1 Scroll saw
2 Blade guard
3 Owner's manual
4 T-style too

MOTOR SPECIFICATIONS AND ELECTRICAL REQUIREMENTS

This machine is equipped with a 750~1500 RPM motor. It is wired for operation on 230 volts, 50 Hz alternating
current. For replacement motor refer to parts list in this manual.
If you are not sure that your outlet is properly grounded, have it checked by a qualified electrician. Your unit is for
use on 230 volts, this power tool is equipped with a 3-conductor cord and grounding type plug approved by VDE
0620. Plug power cord into a 230 volt properly grounded outlet.
The use of any extension cords will cause some loss of power. Use only 3 wire extension cords which have
grounding type plugs and 3-pole receptacles which accept the tool's plug.
Extension Cord Length
Up to: 30.5m
61m
122m
Qty.
1
1
1
1
Wire Size (mm dia.)
For any technical questions, please call 1-800-665-8685
1.5mm
2.0mm
2.5mm
4
8159642