Wiring Diagram; Troubleshooting - Power Fist SS13W Owner's Manual

WIRING DIAGRAM

TROUBLESHOOTING

WARNING: FOR YOUR OWN SAFETY, ALWAYS PUSH THE OFF SWITCH "O" AND UNPLUG
THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE TROUBLESHOOTING
YOUR SCROLL SAW.
PROBLEM
Breaking blades
Motor will not run
Vibration
NOTE: There will always be some
vibration present when the saw is
running because of the motor
operation.
Blade Runout -
Blade not in-line with arm motion
PROBABLE CAUSE
1. Wrong tension
2. Over working blade
3. Wrong-blade application
4. Twisting blade in wood
1. Defective cord or plug
2. Defective motor
1. Improper mounting of saw
2. Unsuitable mounting surface
3. Loose table or table resting against
motor
4. Loose motor mounting
Blade holders not aligned
For any technical questions, please call 1-800-665-8685
REMEDY SUGGESTED
1. Adjust blade tension
2. Reduce feed rate
3. Use narrow blades for cutting
4. Avoid side pressure on blade
1. Replace defective parts before using
saw again
2. Consult the Customer Service Center.
Any attempt to repair the motor may
create a HAZARD. Repairs must be
done by a qualified service technician
1. See mounting instructions in this
manual for proper mounting technique
2. The heavier your work bench is the
less vibration will occur. Plywood
workbench will not be as good a work
surface of solid lumber. Use common
sense in choosing a mounting surface
3.Tighten table lock knob
4.Tighten motor mounting screws
Loosen cap screws holding blade
holders to arms. Adjust position of blade
holders. Retighten holders.
11
8159642