Installation; Mounting The Scroll Saw To A Bench; Getting To Know Your Scroll Saw - Power Fist SS13W Owner's Manual

INSTALLATION

MOUNTING THE SCROLL SAW TO A BENCH

• When mounting this saw to a workbench, a solid wood bench is prefered over a plywood bench where
noise and vibration will be more noticeable.
• Hardware to mount this saw to a workbench is not supplied with the saw. However, we recommended
the hardware used be no smaller than the following.
Quantity Description
2 Hex head screws, 1/4-20" length required
2 Flat washers, 9/32" dia.
4 Hex nuts, 1/4-20"
• A soft foam pad placed between your scroll saw and workbench is NOT supplied with the saw. However,
we highly recommend the used of such a pad to reduce noise and vibration.
Quantity Description
1 Soft foam pad such as carpet padding
228.6 x 381 x 12.7mm (9"x 15"x1/2")
DO NOT overtighten mounting bolts - Leave some cushion in the foam pad for absorbing
noise and vibration.

GETTING TO KNOW YOUR SCROLL SAW

BLADE HOLDER......Retain and position the blade
•
TABLE LOCK KNOB......Loosening the knob
•
allows table to be titled up to 45º for bevel cutting.
Tightening the knob locks the table in the position
you have selected
• BEVEL POINTER......Indicates what angle you have
selected on the bevel scale
BEVEL SCALE......Used to set the approximate
•
table angle for bevel cutting
• BLADE GUARD......Protects hands from blade
contact
HEX BOLT
For any technical questions, please call 1-800-665-8685
FLAT WASHER
LOCK WASHER
HEX NUT
JAM NUT
BLADE HOLDER (LEADER)
GUARD
AIR TUBE
TABLE
TABLE
LOCK KNOB
BEVEL SCALE
8
8159642
FRAME
BLADE
SWITCH
BASE