Table of Contents
Advertisement
c
RS-232/IR (Control) pass-through connector — Connect a serial communications
port to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232
communication (see
connector).
NOTE: The RS-232 connector can also transmit one-way modulated infrared (IR)
signals.
Transmitter Rear Panel
2
Figure 6.
a
DC power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector (see
connector) or the power input connector on the receiver (see b on the following page).
b
Transmitter output port — Connect one end of the twisted pair cable to the
RJ-45 connector on the transmitter (see
properly wire the RJ-45 connectors).
ATTENTION:
data network.
RS-232 and IR connector wiring
SIG
LINK
DTP OUT
DTP 230 D Tx
DTP HDMI 230 D Transmitter Rear Panel Connectors
Power supply wiring
Do not connect this device to a telecommunications or computer
DTP HDMI 230 D Transmitter and Receiver • Installation and Operation
on page 12 to wire the
POWER
12V
0.8 A MAX
1
on page 11 to wire the power
Connector and Cable Details
on page 10 to
7
Advertisement
Table of Contents
