Installation - Seagull Models T-34 Mentor Assembly Manual

Horizontal
90º
Stabilizer.
4) When you are sure that everything
is aligned correctly, mix up a generous
amount of 30 Minute Epoxy. Apply a thin
layer to the bottom of the vertical stabi-
lizer mounting area. Apply epoxy to the
filler blocks. Set the vertical stabilizer as-
sembly in place. As you do this, install
the bottom rudder hinge into the fuselage
without any glue. Re-align the vertical
stabilizer carefully. Double check all of
your measurements once more before the
epoxy cures. Hold the stabilizer in place
with T-pins or masking tape, and remove
any excess epoxy using a paper towel and
rubbing alcohol. Allow the epoxy to fully
cure before proceeding. After the epoxy
is dry, glue the lower rudder hinge with
thin CA.
Epoxy
RUDDER PU SHROD HORN

INSTALLATION.

1) Locate items necessary to install rud-
der pushrod.
WWW.SEAGULLMODELS.COM
Vertical
Stabilizer.
.
Rudder control horn.
2) Rudder pushrods assembly as pictures
below.
8mm
8mm
M2 clevis.
M2 lock nut.
27