Seagull Models T-34 Mentor Assembly Manual page 29

Repeat steps to install the remaining el-
evator pushrod horn.
Elevator pushrod.
INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot,
.
seats.
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well to
the cockpit. (or you can order others scale
pilot figures made by Seagull factory.
They are available at Seagull distributors.)
WWW.SEAGULLMODELS.COM
If you are going to install a pilot figure,
please use a sanding bar to sand the base
of the figure so that it is flat.
3) Position the pilot figure on the can-
opy floor as shown. Use epoxy to glue
the base of the pilot figure to the cockpit
floor, please see pictures as shown.
Epoxy.
50mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fu-
selage using a felt-tipped pen. Carefully
cut and remove covering material from
the fuselage where the canopy makes
contact, exposing the bare wood. Then
permanently glue the canopy in place
with epoxy glue or special "canopy glue".
Epoxy.
Epoxy.
8mm
29