Exerpeutic 1111 Owner's Manual page 13

ASSEMBLY
Tool:
Allen Wrench S6
Multi Hex Tool with
Phillips Screwdriver
3. Front Handlebar Post and Foot Pedal Installation
Remove four M8x15 Bolts (23) and four Ø8 Curve Washers (25) from the Front Main
Frame (5). Slide the Front Handlebar Post Cover (74) up to the Front Handlebar Post
(6).Insert the Tension Cable (40) through into the bottom hole of Front Handlebar Post
(6) and pull it out from the square hole of Front Handlebar Post (6).
Connect the Sensor Wire (61) and Extension Hand Pulse Sensor Wires (65) from the
Front Main Frame (5) to the Extension Sensor Wire (64) and Extension Wires (63)
from the Front Handlebar Post (6). Insert the Front Handlebar Post (6) onto the tube
of the Front Main Frame (5) and secure with four M8x15 Bolts (23) and four Ø8 Curve
Washers (25) that were removed. Slide the Front Handlebar Post Cover (74) down to
the Front Main Frame (5). Remove the M5x25 Bolt (36) and Ø5 Big Curve Washer
(38) from the Tension Control Knob (14).
Put the cable end of resistance cable of Tension Control Knob (14) into the spring hook
of Tension Cable (40) as shown in drawing A. Pull the resistance cable of Tension
Control Knob(14) up and force it into the gap of metal bracket of Tension Cable (40)
and gently remove the Clip (79) after well-connected the resistance cable of Tension
Control Knob (14) and Tension Cable (40) as shown in drawing B. Attach the Tension
Control Knob (14) onto the Front Handlebar Post (6) with the M5x25 Bolt (36) and Ø5
Big Curve Washer (38) that were removed.
The Cranks, Foot Pedals, Pedal Shafts and Pedal Straps are marked "R" for
Right and "L" for Left.
Insert the pedal shaft of Left Foot Pedal (60) into threaded hole in the left Crank (46).
Turn the pedal shaft by hand in the counter-clockwise direction until snug.
Note: DO NOT turn the pedal shaft in the clockwise direction, doing so will strip
the threads.
Tighten the pedal shaft of Left Foot Pedal (60) with the Multi Hex Tool with Phillips
Screwdriver provided. Insert pedal shaft of Right Foot Pedal (59) into threaded hole in
right Crank (46).Turn the pedal shaft by hand in the clockwise direction until snug.
Tighten pedal shaft of Right Foot Pedal (59) with the Multi Hex Tool with Phillips
Screwdriver provided.
11