Leg Kit And Ash Removal System (Ars) Installation - Quadra-Fire 57ST-ACC Installation Manual

B. Leg Kit and Ash Removal System (ARS)
Installation
NOTE: The Ash Removal System, must be
installed fi rst before installing the legs.
Included in Kit: Door assembly, door handle & magnet, ash
drawer, fastener package.
Tools Required: Phillips head screwdriver, 7/16 socket
wrench, 3/32 and 5/36 Allen wrench.
Begin installing the ARS System.
1. Follow steps 1 through 6 on page 17.
Installing Leg Kit
1. Remove leg mounting brackets packaged inside fi rebox.
2. There are 4 screws that are installed on the stove. Remove
the screws and use to secure the mounting brackets to the
stove at the very top and bottom of the brackets. Figure
19.1.
3. There are 6 screws included with the leg kit. Attach 4 of the
screws to the bracket at the bottom, leaving the 2 screws
loose as identifi ed in Figure 19.1.
3. Slide the ash pan assembly bottom slots over the screw
heads. This allows the weight of the ash pan to rest on the
screws while you are attaching the top 2 screws. Once the
ash pan is attached, tighten all screws. Figure 19.2.
3. Loosely assemble bolts into the corner of the mounting
brackets for leg attachment. Figure 19.2.
4. Slide legs onto mounting brackets. Making sure the legs
are up against the bracket and secure with bolts supplied.
There are leveling bolts in 2 legs. These leveling legs
should be in opposite corners. Figure 19.2.
5. Carefully lift stove up and place in desired location. Do NOT
tilt up on the cast iron legs, it could damage the legs.
6. Use leveling bolts on legs to stabilize and level stove.
Finishing the ARS Installation
1. Follow steps 1 through 3 on page 18. See also Figure
18.2.
CAUTION
Do NOT tilt the unit on the cast iron legs.
• Tilting could lead to property damage.
• Lift the unit upright and place it into position on the fl oor
protector.
August 3, 2015
Lay stove flat on its
back on protective
padding or pallet
These 4 screws
are installed on
the stove.
Figure 19.1
Attach ash pan
assembly to stove.
Figure 19.2
7038-206E
5700 STEP TOP
Leg Brackets
packaged inside
firebox
Loosely attach
these 2 screws
Leveling Legs at
Opposite Corners
19