Quadra-Fire 57ST-ACC Installation Manual page 18

5700 STEP TOP
Pedestal and Ash Removal System (Cont'd)
Installing Pedestal Assembly
1. Slide pedestal over adapter on bottom of stove and secure
with screws supplied with the kit. Figure 18.1.
2. Line up holes in sides of pedestal with holes in adapter.
3. Securely tighten pedestal into place.
4. Slip wooden decorative strips onto pedestal edges before
lifting up stove.
5. Carefully stand stove up and place in desired location.
Finishing the ARS Installation
1. Re-install the ash grate channel and secure with 2 bolts
previously removed. Set the ARS access cover and
the 3 front cut bricks in place.
2. Install the ash drawer.
3. Check to make sure baffl e boards and ceramic blanket are
in their proper locations. See page 20 in Owner's Manual.
NOTE: If installing an outside air kit with a pedestal assembly
as a fl oor installation you must attach the enclosed cover
plate to the back of the stove. Other wise you may discard
this piece. Figure 18.3.
Adapters
Figure 18.1
18
Figure 18.2.
Ash Removel
Drawer
Oak
Pedestal
Trim
7038-206E
ARS
Cover
Figure 18.2
Figure 18.3
ARS
Channel
Remove 3 Bricks
from Firebox
Cover
Plate
August 3, 2015