Leg Kit And Ash Removal System Installation - Quadra-Fire 57ST-ACC Owner's Manual

R
C. Leg Kit and Ash Removal System (ARS)
Installation
NOTE: The Ash Removal System, must be
installed fi rst before installing the legs.
Included in Kit: Door assembly, door handle & magnet,
ash drawer, fastener package.
Tools Required: Phillips head screwdriver, 7/16 socket
wrench, 3/32 and 5/36 Allen wrench.
Begin installing the ARS System.
1. Follow steps 1 through 6 on page 41.
Installing Leg Kit
1. Remove leg mounting brackets packaged inside fi re-
box.
2. There are 4 screws that are installed on the stove.
Remove the screws and use to secure the mounting
brackets to the stove at the very top and bottom of the
brackets. Figure 43.1.
3. There are 6 screws included with the leg kit. Attach 4
of the screws to the bracket at the bottom, leaving the
2 screws loose as identifi ed in Figure 43.1.
3. Slide the ash pan assembly bottom slots over the screw
heads. This allows the weight of the ash pan to rest on
the screws while you are attaching the top 2 screws.
Once the ash pan is attached, tighten all screws. Figure
43.2.
3. Loosely assemble bolts into the corner of the mounting
brackets for leg attachment. Figure 43.2.
4. Slide legs onto mounting brackets. Making sure the
legs are up against the bracket and secure with bolts
supplied. There are leveling bolts in 2 legs. These
leveling legs should be in opposite corners. Figure
43.2.
5. Carefully lift stove up and place in desired location. Do
NOT tilt up on the cast iron legs, it could damage the
legs.
6. Use leveling bolts on legs to stabilize and level stove.
Finishing the ARS Installation
1. Follow steps 1 through 3 on page 42. See also Figure
42.2.
CAUTION!
• Do NOT tilt the unit on the cast iron legs. Tilting could
lead to property damage.
• Lift the unit upright and place it into position on the
fl oor protector.
November 28, 2011
5700 Step Top Wood Stove Series ACC
Lay stove flat on its
back on protective
padding or pallet
These 4 screws
are installed on
the stove.
Figure 43.1
Attach ash pan
assembly to stove.
Figure 43.2
7038-159D
Leg Brackets
packaged inside
firebox
Loosely attach
these 2 screws
Leveling Legs at
Opposite Corners
Page 43