Table of Contents
Advertisement
R
Pedestal and Ash Removal System (Cont.)
Installing Pedestal Assembly
1. Remove screws on adapter and slide pedestal over adapter
on bottom of stove. Figure 23.1.
2. Line up holes in sides of pedestal with holes in adapter.
3. Securely tighten pedestal into place.
4. Carefully stand stove up and place in desired location.
5. Slip wooden decorative strips onto pedestal edges.
Finishing the ARS Installation
1. Re-install the ARS channel that was removed in Step 3 on
page one and secure with 2 bolts previously removed.
Set the cover into the ARS channel Replace the 2
front cut bricks. Figure 23.3.
2. Install the ash drawer.
3. Check to make sure baffl e boards and ceramic blanket are
in their proper locations. (see page 29).
NOTE: If installing a fl oor installation of an outside air kit on a
Step Top model with a pedestal assembly you must attach
the enclosed cover plate to the back of the stove. Other wise
you may discard this piece. Figure 23.2.
Adapters
Figure 23.1
Rope to Seal
Pedestal
Figure 23.2
August 3, 2015
B. Leg Kit and Ash Removal Installation
Ash Removel
Drawer
Begin installing the ARS System.
1. Follow steps 1 through 6 on page 22. See also Figures
Oak
Pedestal
Installing Leg Kit
Trim
1. Remove leg mounting brackets packaged inside fi rebox.
2. Attach the 2 bottom screws of the mounting brackets to
3. Loosely assemble bolts into the corner of the mounting
4. Slide legs onto mounting brackets making sure the legs
Cover
Plate
5. Carefully stand stove up and place in desired location. Do
6. Use leveling bolts on legs to stabilize and level stove.
7033-277N
3100 Wood Stove Series (ACC)
Cover
Replace both bricks
back into firebox
Figure 23.3
(ARS) for Step Top Uni-Body
NOTE: The Ash Removal System, must be
installed fi rst before installing the legs.
22.2 and 22.3.
the bottom of the stove with 1/4"-20 Phillips head screws.
These screws are located in the component pack .
Leave the bottom 2 screws loose so you can slide the ash
pan assembly bottom slots over the screw heads. This allows
the weight of the ash pan to rest on the screws while you are
attaching the top 2 screws. Once the ash pan is attached,
tighten all screws. Figure 24.2. (page 24)
brackets for leg attachment. Figure 24.1. (page 24)
are up against the bracket and secure with bolts supplied.
There are leveling bolts in 2 legs. These leveling legs
should be in opposite corners. Figure 24.1. (page 24)
NOT tilt up on the cast iron legs, it could damage the legs.
ARS
Channel
Page 23
Advertisement
Table of Contents
