Fill System
The dishwasher has a fill volume of approximately
.75-.90 gallons of water and is a DC volt circuit.
The water valve is rated at 13.5 VDC, resistance
is 32 ohms and has a flow rate of .83 GPM. The
fill time is 1-minute. The water valve is located in
the front left corner, under the dishwasher.
Components
Fill Hose
Fill Cup
Gasket
Water Valve
Clamp
Pressure
Switch
– 39 –
Water Level
To check for proper water level, place the
dishwasher in Service Mode and run the Fill Test.
Water must reach the level shown below.
Pressure Sensor
A pressure switch is used to monitor water level.
The switch provides feedback to the control. The
pressure switch is located on the front of the
sump.
Minimum
Water
Level
(Continued next page)