Installing The Alkaline Ionizer - Panasonic TK-AS40 Instruction Manual

Installing the Alkaline Ionizer/ 安裝本體
Installation precautions/安裝上的注意事項
Do not install the Alkaline Ionizer in any of the following locations: (Doing so may cause malfunction.)
Where there are naked flames or near other high-temperature area (above 60 °C)
Where the Alkaline Ionizer will be exposed to direct sunlight
Where oil or grease will stick to the Alkaline Ionizer
Outdoors or where the Alkaline Ionizer will be exposed to the wind and rain
In a bathroom or where the Alkaline Ionizer will be exposed to water or steam
Where it may freeze
Do not use a hose or other such product sold on the market to extend the water outlet. (Doing so may
cause malfunction.)
Do not connect the Alkaline Ionizer to a hot water-only faucet. (Doing so may cause malfunction.)
CAUTION
Install the main unit on a level surface.
The main unit may topple over if it is installed on an unstable surface, possibly causing injury.
When mounting the main unit on a wall for use, be absolutely sure to ask your dealer or a contractor to
do the installation work.
If you try to do the work yourself, the main unit may fall off, possibly causing an accident.
For details concerning wall mounting, refer to "Optional Accessories" on page 53.
Do not block the water outlet or bend, twist or flatten the hose.
Doing so may cause water to leak, prevent the output of water with the proper pH level or cause other
malfunctions.
Do not connect a hose or any other appliances to the main spout.
Doing so may cause water to leak.
Do not connect the Alkaline Ionizer to a hot water supply system which is not equipped with a
directional control check valve (for preventing the backflow of the water).
Doing so may lead to malfunction in the hot water supply system.
Do not connect the Alkaline Ionizer to a main stop system water boiler such as an instantaneous water
heater (whose construction does not permit the water to be stopped at the hot water outlet).
Doing so may lead to malfunction in the water boiler or heater.
請勿安裝符合以下場所。 （易造成故障）
使用火的地方、靠近其他高溫處（60 ℃以上）
黏附油污的地方
浴室或容易有水或蒸氣的地方
請勿使用市面上販售的水管等加長於出水口。 （ 避 免 故 障 ）
請勿安裝於熱水專用的水龍頭。 （ 避 免 故 障 ）
注意
本體請設置於平坦的地方
避免設置於不穩定的狀態下，易造成翻落，導致受傷。
欲將本體設置於壁面時，務必請經銷商或水電行施工
避免自己設置，亦造成落下或事故的原因。
壁面安裝，請參閱 53 頁。
請勿堵塞出水口、彎曲凹折水管、扭曲擠壓
避免漏水或流不出適當的 pH 值水，而故障的原因。
出水口處請勿接用水管或其他器具
避免造成漏水或故障的原因。
請勿安裝於沒有防逆流裝置的熱水器
避免造成熱水器故障的原因。
請勿安裝在熱水器專用的水龍頭上（無法控制熱水的出水設計）
避免造成熱水器故障的原因。
18
直接照射日光的地方
室外或風吹雨打的地方
可能會結凍的地方 等