Panasonic TK-AS40 Instruction Manual page 21

Installing the Alkaline Ionizer (continued)
1
After completing the preparations,
connect the water supply hose.
q Remove the hose fastening nut from the bypass
selector, and pass the hose through the nut.
e Tighten up the hose fastening nut securely.
Do not use any tools for this job (since the hose
●
fastening nut may be damaged).
4
Secure the drain hose using the suction disc.
Secure the hoses so that they will not move out of place.
Installation position
The tip of the drain hose must be below the level of the bottom of the main unit and the
difference in height between the main spout and tip of the drain hose must be greater than
10 cm and less than 50 cm (so that the appropriate pH level (ion concentration) is achieved).
20
w Insert the water supply
hose into the bypass
selector as far as it will go.
OK
Main spout
Height difference
Drain hose
2
Secure the water supply
hose
NG
Gap
Bottom of main unit
(using the hose strap)