Panasonic TK-AS40 Instruction Manual page 22

3
Screw in the outlet pipe until it is secured firmly.
Do not use any tools for this job (since the pipe may be damaged).
Ensure that the gasket is not twisted (since this may cause the water to leak).
Do not lift the main unit by taking hold of the outlet pipe (otherwise damage
may result).
5
Connect the power plug to the power outlet
The buzzer beeps three times and the water quality indicator lamp lights up at purified water.
The Alkaline Ionizer's power consumption is 1 W even in the standby status.
Important
After installing the Alkaline Ionizer, run purified water through the unit for about 3 or 4
minutes to expel the air inside the main unit.
The power plug is normally kept connected to the power outlet (to keep the automatic
electrode cleaning function working).
Note
If the hose is too long, it is recommended that you cut it to the proper length (cut it straight down).
Immediately after the Alkaline Ionizer has been installed, the water quality indicator lamp blinks for
about 10 - 40 seconds when water is run through the Alkaline Ionizer. (See page 9.)
Gasket
Caution label
Affix the label on
the main unit or at
an easily viewable
location near the
main unit.
(AC 220V-240V).
21