Preparation For Starting Up - WAGNER GM 4600AC Operating Instructions Manual

Aircoat

Hide thumbs Also See for GM 4600AC:

Table of Contents

EDITION 02/2008

OPERATING MANUAL

5.3.2

PREPARATION FOR STARTING UP

1. Secure the spray gun.

2. Connect material hose to the spray gun and material supply system.

3. Connect air hose to spray gun and to oil-free, dry air supply with regulator.

4. Insert suitable gun ﬁ lter

5. Place the nozzle into the nozzle seal. Fit the air cap over the nozzle, ensuring that the

location ﬂ ats (X) are in line. Fit the union nut with nozzle guard and tighten by hand.

6. Visually check the permissible pressures for all the system components.

7. Make sure that the unit and all other conductive parts within the work area are

earthed.

8. Set material pressure 100 bar; 10 MPa; 1450 psi and use a suitable medium (solvent or

water) to check that connections do not leak.

Note:

Pull the trigger and then release, checking that the gun closes cleany.

9. Relieve spray gun and unit pressure and secure the spray gun.

Part No. DOC394861

GM 4600AC

B_02261

Table of Contents