Table of Contents
Advertisement
EDITION 02/2008
OPERATING MANUAL
6.3
CHANGING OR CLEANING FILTER INSERT
1. Finishing work and cleaning.
2. Relieve spray gun and unit pressure.
3. Secure gun with trigger safety catch.
4. Place open-ended wrench A on fl ats of fi lter housing (30) and counter hold.
5. Turn nut to the right with open-ended wrench B and unscrew pivot joint (67) with
material hose.
6. Remove the fi lter insert (64), seal (65) and compression spring (66).
7. Thoroughly clean all parts with cleaning agent.
8. Assembly:
Push cleaned or new fi lter insert (64) with cone upwards into the fi lter housing (30)
9. Insert compression spring (66) into fi lter connection piece (67). Screw on the fi lter
connection piece with seal (65) and material hose by hand and tighten using the two
open-end wrenches A and B.
Counter hold
A
30
64
Description
GM 4600AC with fi lter NPS1/4"
Part No. DOC394861
65
66
67
B
B_02677
Key A
SW 15 mm
0.590 inches
B_02679
Key B
SW 17 mm
0.669 inches
GM 4600AC
Note:
Do not unscrew the fi lter
housing. The nut must only be
unscrewed by WAGNER-Serv-
ice-Agency.
27
Advertisement
Table of Contents
