Preparation Before Starting Work; Set Up And Connect; Typical Electrostatic Spraying System - WAGNER GM 2800EA Operating Manual

EDITION 03/ 2007
OPERATING MANUAL
5

PREPARATION BEFORE STARTING WORK

5.1

SET UP AND CONNECT

5.1.1

TYPICAL ELECTROSTATIC SPRAYING SYSTEM

Incorrect installation/operation!
Risk of injury and damage to equipment
SIHI_0050_GB
A Paint-pump
B Air shut off valve
C Air regulator
D Air regulator with fi lter
E Earthing cable
F Air hose
G Fan air regulation
The spray gun GM 2800EA must be used a part of an electrostatic spraying system. The
spraying system shown in the fi gure is only one example of an electrostatic AirCoat spray-
ing system. It is not an actual system design. Contact your WAGNER distributor for assist-
ance in designing a system to meet your needs. The operating instructions and the safety
regulations for the additional system components used must be read before starting-up.
PART NO. DOC388891
WARNING
When putting into operation and for all work, read and follow
the operating instructions and safety regulations for the addi-
tionally required system components.
H
I
K
L
O
P
Q
Gun cable to control unit
Control unit
Paint connection
Fluid hose
Stand
Paint container
Mains air inlet
GM 2800EA
20