Base Frame - BodyCraft X2 Instruction Manual

To ease the assembly process, do not tighten bolts until instructed.
1. Attach Base Stabilizers(2) to each end of Base Frame(1), using two 1/2" X 3" Hex Head Bolt(123) and
two 1/2" nut(153). Attach 50mm SQ. Cap(62) onto front & rear Base Stabilizers(2).
2. Attach Weight Stack Base - Leg Press Side(5) and Weight Stack Base - Low Row Side(6) to Base
Frame(1) using two 1/2" X 3" Hex Head Bolts(123), two 1/2" Washers(146) and two 1/2" Nylon nuts
(153). Attach four 50mm SQ. Plugs(64) and insert four Plastic Guide Rod Holders(72) to both Weight
Stack Bases(5, 6).
3. Attach Front Upright(4) to Base Frame(1) using two 3/8" X 3" Hex Head Bolts(128), four 3/8" Washers
(147) and two 3/8" Nylon Nuts(154). Repeat process for Rear Upright(3). Screw Longer Pop Pin(77)
into Front Upright(4) and Rear Upright(3) as shown.
4. Attach Low Row Base(9) to Weight Stack Base(6) using two 1/2" X 3" Hex Head Bolts(123) and one
1/2" Nylon Nut(153). Attach Row Plate(14) to Low Row Base(9) by inserting 1/2" Row Plate Roller(15).
Insert 1/2" Round Plug(70) into 1/2" Row Plate Roller(15). Attach 100 X 150mm Non Slip(93) to Row
Plate(14).
5. Attach Leg Press To Weight Base Connector(51) to Weight Stack Base(5) using two 3/8" X 2-3/4"
Hex Bolts(130), four 3/8" Washers(147) and two 3/8" Nylon Nuts(154).
6. Attach Long Leg Press Connector(49) to Base Frame(1) using two 3/8" X 3" Hex Head Bolts(128), four
3/8" Washers(147) and two 3/8" Nylon Nuts(154).
93
140
14
70
93
15
70
S
T E P 1 ASSE M BL E BASE FR AM E
72
72
64
153
9
62
153
123
2
64
4
64
123
153
77
6
153
154
147
154
154
147
1
147
128
153
147
128
62
7
77
3
62
153
154
147
147
72
128
147
123
64
5
147
130
123
147
51
130
49
123
153
2
62