Table of Contents
Advertisement
STEP 2
1.Attach the Seat Support (5) to the Front Upright (2) using two 3/8" X 3-1/8" Hex Bolts (67), four 3/8"
Washers (80) and two 3/8" Nylon Nuts (83).
2.Attach the Seat Support (5) to the Base Frame (1) using one 3/8" X 4-3/4" Hex Bolt (66), two 3/8"
Washers (80) and one 3/8" Nylon Nut (83).
3.Attach the Seat Pad (30) to the Adj. Seat Arm (6) using two 3/8" X 2-3/4" Threaded Hex Bolts (71)
and two 3/8" Washers (80), then insert the Adj Seat Arm (6) into the Seat Support (5). Insert two
50mm Sq. Plugs (54) into Adj. Seat Arm (6).
4.Attach the Leg Extension Arm (7) to the Seat Support (5) using the 1/2" Axle (37). Fasten the 1/2"
Axle (37) using two 5/16" Spring Washers (82), two 5/16" Washers (81) and two 5/16" X 5/8" Inner
Hex Screws (75). Insert two 50mm Sq. Plugs (54) into each end of the Leg Extension Arm (7).
5.Insert a Foam Roller Holder (32) into the hole in the Leg Extension Arm (7) and into the hole in the
Adj. Seat Arm (6). Moisten the inside hole of each Foam Pad (35) with water and slide onto each end
of the Foam Roller Holders (32). Attach a 1" Plug (56) onto each end of the Foam Roller Holders
(32).
6.Attach the Back Pad (31) to the Back Pad Adjuster (8) using two 3/8" X 1" Threaded Hex Bolts (72)
and two 3/8" Washers (80), then insert the Back Pad Adjuster (8) into the Front Upright (2). Insert a
45mm Sq. Plug (55) into the end of the Back Pad Adjuster (8).
7.Attach the Foot Plate (17) to the Base Frame (1) by aligning the holes and inserting the 1/2" Round
Tube (33). Insert two 1/2" Plugs (58) into the 1/2" Round Tube (33).
56
35
56
35
32
58
33
17
Seat Frame Assembly
78
32
80
54
71
75
82
37
81
54
81
5
66
7
80
77
35
56
54
58
30
6
54
80
80
8
71
80
31
35
80
67
80
67
82
75
76
6
2
72
55
72
83
80
56
1
80
83
Advertisement
Table of Contents
