Figure 6 Internal Scsi Tape Drive Scsi And Power Cable Location - Quantum DLT V4 User Manual

Figure 6 Internal SCSI Tape
Drive SCSI and Power Cable
Location
DLT-V4 Product Manual
Obtain a SCSI cable with an open 68-pin, high-density connector.
7
Connect one end of the SCSI cable to the SCSI connector on the rear
panel of the tape drive. The SCSI connectors are keyed, preventing
improper connection (see
If the SCSI cable does not fit the connector on the SCSI
Note:
host adapter, you either have an incompatible SCSI host
adapter or you need to purchase a cable adapter. Contact
your sales representative or the SCSI host adapter
manufacturer for information. See
Internal SCSI Tape Drive
need to use an LVD/SE terminator with the SCSI cable.
Connect the other end of the SCSI cable to the SCSI host adapter,
8
aligning the colored stripe on the cable with pin 1 on the SCSI host
adapter's connector.
Locate an available power cable in the server or workstation and
9
attach it to the power connector on the rear panel of the tape drive
(see figure 6). The connector is keyed, preventing improper
connection.
Chapter 2 Installing the Internal SCSI Tape Drive
Installing the Internal SCSI Tape Drive
figure 6).
on page 8 to determine if you
SCSI cable
(shown with terminator installed)
Terminating the
Power
cable
13