Using The Cordless Handset (Remote Operation) - Panasonic KX-TG2770CS Operating Instructions Manual

✻✴✥✪✪✣✰✲✻✮M.❇m ✩✣
Listening to Messages
Using the Cordless Handset
(Remote Operation)
If " " flashes, there are new messages in the mailboxes. If there are only old
PLAY
messages " " is displayed but will not flash.
PLAY
To play back messages
1
Press the soft key (
• A beep sounds and " Please select Mailbox " will be
heard from the speaker. To switch to the
receiver, press [
speaker, press [
• The mailboxes that have new messages will
flash.
2
Press [#][1] (Mailbox 1), [#][2] (Mailbox 2) or
[#][3] (Mailbox 3).
• If " Enter Mailbox password " is announced and
displayed, Mailbox 2 or 3 has a password. Enter
the password (p. 57).
• " Mailbox (No.) " and the number of new
messages will be announced, and new
messages will be played.
• To play all messages in the mailbox, press [5] .
• If you do not press any buttons, the voice menu
will start (see below).
3
To end remote operation, press [OFF] .
• If you do not select a mailbox in step 2, new messages in Mailbox 1 will be played.
• " " will not disappear after listening to messages.
PLAY
• You can switch to another mailbox by pressing [#] and the mailbox number ( [1] to
[3] ) during the remote operation.
• If a call is being received during playback, you will hear incoming call tones
(p. 53). To answer the call, press [
beginning after hanging up.
Voice menu
If you do not press any buttons at the end of the last message and hear " End of final
message ", the cordless handset will start the following voice menu.
" Press 4 to play back new messages. Press 5 to play back all messages. "
• You can press buttons for other playback options (p. 61) or select another mailbox
by pressing [#] and the mailbox number ( [1] to [3] ) even if the voice menu has
started.
60
] ]
Handset
)
.
PLAY
] . To switch back to the
] .
] or [ ] . For playback, start again from the
_
e.g. New messages exist.
Received calls
P L AY
e.g. Mailbox 1 has new
messages.
Remote operation
#,1=Mailbox1
#,2=Mailbox2
#,3=Mailbox3