Kinematic; Rtk Base - ashtech Z-Xtreme Operations & Reference Manual

KINEMATIC

• SITE (SITE:****)
Sets the four character SITE name.
• Epoch Log counter (LOG #:***)
If the epoch counter in the SURVCONF menu has been set to a value
other than 0 and the SITE has been entered (which must be done after
you have set the antenna on the desired point), the display enters the LOG
# screen and the log counter begins decrementing starting from the epoch
counter value (at the rate of the recording interval set in the SURVCONF
menu).
• Incremented SITE (Site:****?)
Once the log counter reaches 0 (when enough epochs have been
recorded for the current site), the receiver beeps and the B-file reverts to
????. The display automatically increments the SITE while waiting for the
user to set up at the new point.You can then accept or reject the proposed
SITE.
The SITE is automatically incremented only if the last character (on the
right) is a number. When this number reaches 9, it rolls back to 0. If the
character on the left is also a number, it gets incremented, and so on.
The characters which are not incremented and the ones on the left of the
first character which are not numbers, are ignored (the same SITE is
used for the new point).
Even if all the SITE characters are letters, the display will still go to the accept/refuse menu. You will
need to refuse before being able to enter a new SITE. If you accept, the same SITE will be used for
the new point.
• Antenna Height (ANT HT:**.****m)
Sets the height of the GPS antenna
• Survey Status (STATUS)
is a submenu with information listed in Table 4.3.
STATUS

RTK BASE

• SITE (SITE:****)
Sets the four-character SITE name.
• Antenna Height (ANT HT:**.****m)
Sets the height of the GPS antenna
• Antenna Radius (ANT RAD:*.****m)
Sets the radius of the GPS antenna.
• Base Position (BASE POS) (submenu)
The base position is associated with the following information:
• Latitude (LAT:N/S**º**'**.*****")
Operations 35