Installation; Figure 3.2 Installing An Internal Battery - ashtech Z-Xtreme Operations & Reference Manual

Installation

1. Orient the Z-Xtreme so that you are looking at the front panel.
2. Open the memory/battery door (Figure 3.2).
3. Orient the battery so the connector is on the right side while pointing towards
the battery bay.
4. Slide the battery into the battery slot until it seats into the battery connector.
The battery connector is keyed so it only seats into the battery bay connector
one way. While this feature assists in the insertion of the battery, it is possible to
force the battery into the bay improperly. Improper installation of the battery may
damage the Z-Xtreme.
5. Close the memory/battery door.
Operation of the receiver on internal battery, with the radio or other peripheral
device connected to the external 12V on the serial ports, will shorten battery life.
Avoid a deep discharge of the battery below 9V as permanent damage to the battery
can result.
Getting Started
Figure 3.2 Installing an Internal Battery
CAUTION
CAUTION
23