Section 5 − Operation; Controls - Miller Millermatic 350P Technical Manual

5-1. Controls

1
2
3
4
5
6
1 Pulse Indicator Light
.
Pulse only lights if unit has the pulse
MIG module and is programmed for
pulse MIG.
2 MIG Indicator Lights
Pulse (1) and MIG (2) illuminate to Indicate
weld mode of unit.
3 Process Light
PROCESS illuminates when unit is in
Process select menu.
4 Wire Light
WIRE illuminates when unit is in Pulse MIG
program select menu.
5 Timers Light
TIMERS illuminates when unit is in Timers
menu.
6 Setup Button
Millermatic 350
SECTION 5 − OPERATION
10
8
Use button to access Timers, Process and
Wire menus.
7 Arc Control Button
Use button to select either inductance
control in MIG welding mode or Sharp Arc
in Pulse MIG welding mode.
8 Left Knob
Use knob to adjust volts in MIG welding
mode or change parameter values in
Setup.
9 Right Knob
Use knob to adjust wire speed in MIG
welding mode or change parameter values
in Setup.
10 Left Display
11 Right Display
11
9
12 Weld Functions/Setup Indicator
Lights
VOLTS illuminates in MIG welding mode
indicating volts in left display can be
adjusted. Also, VOLTS lights to indicate left
display is showing actual voltage during
welding and for 5 seconds after the arc is
extinguished.
ARC LENGTH illuminates in Pulse MIG
welding mode indicating Arc Length can be
adjusted.
SETUP illuminates when a parameter on
the corresponding display above the light
can be adjusted.
WIRE SPEED illuminates in either Pulse
MIG or MIG welding mode indicating wire
speed can be adjusted.
AMPS illuminates indicating welding amps
appears in the display, instead of wire
speed, during welding and for 5 seconds
after the arc is extinguished.
12
7
Ref. 213 935-A
TM-1327 Page 21