4-1. Controls
1
Polarity Selector Switch (Optional On
50 Hz Models)
To change polarity on models not equipped
with a Polarity Selector switch, reverse work
and electrode cables at the weld output ter-
minals (see Section 3-5).
Y Turn Off Power before reversing
cables.
2
Arc Force (Dig) Control
Control increases SMAW short-circuit
amperage which allows the operator to use
a very short arc length without sticking the
OM-222 Page 14
SECTION 4 − OPERATION
1
2
9
electrode.
Set control at 0 for normal welding
amperage. Turn clockwise to increase short-
circuit amperage.
3
Hot Start Switch
Turn switch On for SMAW and Off for GTAW
welding.
4
Amperage Adjustment Control
5
Digital Meters (Optional)
6
Power Switch With Indicator Light
7
High Temperature Shutdown Light
3
4
5
8
8
Remote Amperage Control Switch
For front panel control, place switch in Panel
position. For remote control, place switch in
Remote position, and connect remote de-
vice (see Section 3-7).
9
Output Switch (Contactor)
For front panel control of output, place switch
in Panel position. For remote control of out-
put, place switch in Remote position, and
connect remote device (see Section 3-7).
Y Turn Off power before connecting re-
mote device.
7
6
Ref. ST-800 101-C