Changing Drive Roll And Wire Inlet Guide - Miller Millermatic 350P Technical Manual

10-5. Changing Drive Roll and Wire Inlet Guide

.045 Groove
Stamped
.035
Tools Needed:
3/8 in.
Millermatic 350
.035 Groove
Stamped
.045
2
1
4
1
5
3
1 Securing Screw
2 Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3 Intermediate Guide
4 Drive Roll
.
The drive assembly comes
equipped with factory installed
.035/.045 combination drive
rolls. Be sure that all 4 drive
rolls are installed correctly.
Combination drive rolls consist of
two different sized grooves. The
wire size you are using should
appear on the face of the drive roll
when installed.
Install correct drive roll for wire size
and type.
.
U-Grooved drive rolls are re-
quired for feeding aluminum
wire.
5 Drive Roll Securing Nut
Turn nut one click to secure drive
roll.
802 520-C
TM-1327 Page 71