Removing The Evaporator Fan Motor - Whirlpool ACP102PR Manual

REMOVING THE EVAPORATOR FAN MOTOR

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug air conditioner or disconnect power.
2. Remove the cabinet from the unit (see
page 4-2 for the procedure).
3. Remove the components cover (see
page 4-5 for the procedure).
4. Cut the indicated wire tie from around the
evaporator fan motor wires.
Evap. Fan Motor
Cut Wire Tie
5. Disconnect the evaporator fan motor
wires from the following control board
connectors:
a) White wire at CN10
b) Black wire at CN6
c) Yellow wire at CN4
6. Disconnect the two red wires from the
evaporator fan motor capacitor terminals.
Motor Cap Wires
7. Remove the louver motor from the louver
(see page 4-5 for the procedure).
8. Unhook the right end, pull the left end out
of the housing hole, and remove the lou-
ver from the top of the unit.
Continued on the next page.
4-9
CN10
CN6
CN4
Unhook Louver