6.
Remove the four screws from the con-
denser fan motor.
7.
Remove the screw from the condenser
fan motor green ground wire.
8.
Raise the locking tab on the wire tie
standoff, and pull the strap and wires out
of the standoff.
9.
Cut the indicated wire tie from the wires.
Standoff
Wire Tie
Motor Ground
10. Cut the remaining wire ties that are nec-
essary to remove the condenser fan mo-
tor wires from the chassis.
11. Disconnect the two red wires from the termi-
12. Unlock and disconnect the 3-wire con-
Fan Motor
Screws
4-19
nals of the condenser fan motor capacitor.
nector from the control board at CN21.