REMOVING THE POWER SUPPLY CORD
1.
Unplug air conditioner or disconnect power.
2.
Remove the cabinet from the unit (see
page 4-2 for the procedure).
3.
Position the unit with the rear of the unit
facing you.
Condenser Fan Motor Housing
Strain Relief
Power Supply Cord Terminal Cover
4.
Remove the two screws from the termi-
nal cover and remove the cover.
Terminal Cover
5.
Loosen the three terminal clamp screws,
and pull the flat pins on the ends of the
green, white, and black power supply
cord leads out of the clamp.
Flat Pin
6.
Using a 90˚ Phillips screwdriver, remove
the screw from the strain relief plate, and
remove the strain relief and power supply
cord from the unit. NOTE: If you cannot
remove the strain relief plate screw as
described, remove the eight screws from
the condenser fan motor housing (see
the left photo), and remove the housing
to access the strain relief.
7.
Remove the screws inside the strain re-
lief and remove the power supply cord.
Plate
Screw
4-26
Screws
Grn
Wht
Blk
Strain
Relief