Portable Air Conditioner Care - Whirlpool ACP102PR Manual

PORTABLE AIR CONDITIONER CARE

A. Air filter
B. Drain plug
CLEANING THE AIR FILTER
1. Press POWER to turn off the air condi-
tioner.
2. Remove the filter by sliding it up.
3. Use a vacuum cleaner to clean the air filter.
If filter is very dirty, wash air filter in warm
water with a mild detergent.
NOTE: Do not wash air filter in the dish-
washer or use any chemical cleaners.
4. Air dry filter completely before replacing
to ensure maximum efficiency.
CLEANING THE OUTSIDE
1. Unplug air conditioner or disconnect
power.
2. Remove the air filter and clean separately.
See "Cleaning the Air Filter."
3. Wipe outside of air conditioner with a soft,
damp cloth.
4. Plug in air conditioner or reconnect power.
5. Press POWER to start the air conditioner.
A
B
DRAINING THE AIR CONDITIONER
1. Press POWER to turn off the air condi-
tioner.
2. Unplug air conditioner or disconnect
power.
3. Move the air conditioner to a drain location
or outside.
4. Remove the rubber drain plug and allow
water to drain from the air conditioner.
5. Reinstall the drain plug.
6. Reposition air conditioner.
7. Plug in air conditioner or reconnect power.
8. Press POWER to start the air conditioner.
NOTE: A drain hose may also be connected to
drain port to drain water from air conditioner.
See "Install Portable Air Conditioner" on page
2-3 for location of drain port.
STORING AFTER USE
1. Remove drain plug and drain water com-
pletely.
2. Run unit with fan only for approximately
12 hours to dry the unit.
3. Unplug unit.
4. Remove filter and clean. See "Cleaning
the Air Filter."
5. Clean the outside of air conditioner. See
"Cleaning the Outside."
6. Reinstall filter.
7. Remove batteries from remote control and
store with unit in a clean, dry area.
8. Remove air hose and store with unit in a
clean, dry area. See "Installation Instruc-
tions."
3-9