Portable Air Conditioner Use - Whirlpool ACP102PR Manual

PORTABLE AIR CONDITIONER USE

A B
E F
NOTES:
• Remote control may vary in appearance.
• Two AA batteries (not included) power the remote control. Do not
use rechargeable batteries. Replace batteries after 6 months of
use, or when the remote control starts to lose power.
• To operate the air conditioner with the remote control, aim the
remote control at the signal receptor from no more than 23 ft
(7 m) away.
A. RUN indicator light
B. WATER FULL indicator light
C. Display
D. TEMP/TIME plus and minus buttons
USING THE CONTROL PANEL
Display Symbols
A
B
C
D
E
A. Remote control D. Dry mode indicator
signal transmit light
indicator light
E. Fan only mode
indicator light
B. ComfortMode
TM
indicator light
F. Auto fan speed
indicator light
C. Cooling mode
indicator light
C D
G
H
E. TIMER OFF button
F. TIMER on button
G. POWER button
H. FAN SPEED button—choose Auto, High or Low
F
G
H
I
G. High fan speed
indicator light
H. Low fan speed
indicator light
I. Display set
temperature
3-3
C
G
J
I
H
F
E
I. MODE button—choose ComfortMode
Cooling, Dry or Fan Only
J. RapidCool
K. SWING air direction control
NOTES:
• The air conditioner display shows the current
room temperature and 24 hour clock.
• In the event of a power failure, your air con-
ditioner will operate at the previous settings
when the power is restored.
• When changing modes while unit is operating,
the compressor will stop for 3 to 5 minutes
before restarting. If a button is pressed dur-
ing this time, the compressor will not restart
for another 3 to 5 minutes.
• In Cooling or Dry mode, the compressor and
fan will stop when room temperature reaches
set temperature.
control,
™
mode control
™
D
K
I
D
I