Whirlpool ACP102PR Manual page 25

Air conditioner runs, but does not cool
• The filter is dirty or obstructed by debris. Clean
the filter.
• Air outlet is blocked. Clear air outlet.
• Set temperature is too high. Lower set temperature.
• The air conditioner has lost charge (leak in
system), or operated in temperatures below
64ºF (18ºC). If the control buzzer beeps 3 times
repeatedly, contact service technician.
Air conditioner cycles on and off too much
• The unit is set to ComfortMode
™
ComfortMode control only when you are away
from home or asleep, since the fan does not
circulate the room air continuously.
• The air conditioner is not properly sized for
your room. Check the cooling capabilities of your
portable air conditioner. Portable air conditioners
are not designed to cool multiple rooms.
• The filter is dirty or obstructed by debris.
Clean the filter.
• There is excessive heat or moisture (open
container cooking, showers, etc.) in the room.
Use a fan to exhaust heat or moisture from the
room. Try not to use heat-producing appliances
during the hottest part of the day.
• The louvers are blocked. Install the air condi-
tioner in a location where the louvers are free
from curtains, blinds, furniture, etc.
• The outside temperature is below 64°F (18°C).
Do not try to operate your air conditioner in the
cooling mode when the outside temperature is
below 64°F (18°C).
• The temperature of the room you are trying to
cool is extremely hot. Allow extra time for the
air conditioner to cool off a very hot room.
• Windows or doors to the outside are open.
Close all windows and doors.
Temperature on display does not match room
temperature
• When the compressor and fan motor turn off
during normal operations, or after you turn off
the unit, a lower temperature reading than the
actual room temperature may be displayed for
a short period of time. This lower temperature
reading is caused by the temperature sensor
being located close to the cold evaporator coil.
The actual room temperature will display within
a few minutes.
Water drips from cabinet into your house
™
control. Use
• The drain plug is not installed properly. Install
drain plug properly.
Water Full indicator remains on, and the air
conditioner turns off.
• This is normal. See "Portable Air Conditioner
Care" for instructions on how to drain the air
conditioner.
3-11