Table of Contents
Advertisement
Time Control
This feature cannot be used with a SIP terminal.
Several time groups can be configured in the OpenCom 100 / Aastra 800. Depending
on the activated time group, incoming calls are signalled on different terminals. It is
possible to automatically change between these time groups, according to a time-
table set up by the system administrator, or to change them manually.
You can only program this function if the system administrator has activated the
"Time control" authorisation for your user group.
Activating automatic time control
H*8#
This key combination activates automatic time control. The setting remains
unchanged until one of the available time groups is set manually.
Manually setting a time group
H*8* Z
1
#
(number of the time group, e.g.
)
You activate the required time group using this procedure; automatic time control is
then deactivated. Ask your system administrator about the number of configured
time groups.
Deleting All Call Forwarding in the Exchange
This feature cannot be used with a SIP terminal.
H*184 Z
#
(system PIN)
Call forwarding can be set up in the network operator's exchange. For setting up new
call forwarding or finding faults, it can be useful to delete all active call forwarding in
the exchange. Using the above code-number procedure, you can do this from any tel-
ephone.
Deleting the call forwarding in the exchange is a background function. After you
entered the procedure this process will take time (up to 15 seconds for each line).
Please have patience with this.
The system PIN is issued by the system administrator. It must have been changed
from the factory setting "0000" valid on delivery to another value.
36
Hide quick links:
Advertisement
Table of Contents
