CyberData 011097 Operation Manual page 38

2. On the Network Configuration page, enter values for the parameters indicated in
Web Page Item
Stored Network Settings
IP Addressing*
IP Address*
Subnet Mask
Default Gateway
DNS Server 1*
DNS Server 2*
Current Network Settings
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
3. After changing the parameters, click Save Settings. This updates the changed parameters. The
4. Connect the Loudspeaker Amplifier to the target network.
5. From a system on the same network as the Loudspeaker Amplifier, open a browser with the new
Operations Guide
Table 2-13. Network Configuration Parameters
Loudspeaker Amplifier must be rebooted for changes to take effect.
IP address of the Loudspeaker Amplifier.
Configure the Loudspeaker Amplifier Parameters
Description
Select either DHCP IP Addressing or Static IP Addressing by
marking the appropriate radio button. If you select Static, configure
the remaining parameters indicated in
DHCP, go to Step 3.
Enter the Static IP address.
Enter the Subnet Mask address.
Enter the Default Gateway address.
Enter the DNS Server 1 address.
Enter the DNS Server 2 address.
Shows the current network settings.
Shows the current IP address.
Shows the current Subnet Mask address.
Shows the current Default Gateway address.
Shows the current DNS Server 1 address.
Shows the current DNS Server 2 address.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
930362L
Installing the VoIP V2 Loudspeaker Amplifier
Table 2-13 . If you select
CyberData Corporation
30
Table 2-13.