S70 SERIES USERS MANUAL
2.
All Connected Equipment must be UL or CSA approved.
3.
The Product must be plugged into a properly wired and grounded outlet. Use of input surge
devices, extension cords, adapters, ground wires, or electrical connections not manufactured by
XPC voids the XPC Load Protection Policy. No other surge protection device may be connected to
the output sockets of the Product. The installation must comply with all applicable electrical and
safety codes set forth pursuant to the NEC.
4.
The Product must have undeniable physical evidence of a Power Disturbance that directly and
proximately caused the damage;
5.
The Connected Equipment must have been damaged by a Power Disturbance on a properly
installed, grounded, and National Electric Code, ("NEC"), code‐compliant 120, 208, 240‐volt AC
power line in the United States or Canada, by a Power Disturbance on standard telephone land
line or PBX telephone equipment line that is properly installed and connected to an RJ11 port on
the Product; or by a Power Disturbance on a standard Local Area Network connection that is
properly installed and connected to an RJ45 port on the Product and (d) is directly plugged into,
and properly connected to, the Product in its original condition which was properly operated
when a Power Disturbance passed through the Product and (i) exhausts the protection capacity
of the Product or (ii) damages the Product.
6.
The Load Protection Policy does not apply if the Product has been operated in a failure mode or
not in compliance with XPC operating instructions in the Product user's manual, or if the
Connected Equipment has not been operated in compliance with the instructions and manuals
of its manufacturer/vendor.
7.
This policy is null and void if, XPC determines, in its sole discretion, that the Product has been
tampered with or altered in any way.
What is Not Covered Under the Load Protection Policy:
The following damage is not covered by this Policy:
1.
Restoration of lost data and reinstallation of software.
2.
Damage from a cause other than AC power‐line transients, except for damage due to telephone
line, Local Area Network, or CATV transients, which is covered only if the Product offers such
protection.
3.
DAMAGE CAUSED BY FAILURE TO PROVIDE A SUITABLE INSTALLATION ENVIRONMENT FOR THE
PRODUCT (INCLUDING, BUT NOT LIMITED TO, LACK OF A PROPER SAFETY GROUND).
4.
Damage caused by the use of the Product for purposes other than those for which it was
designed.
5.
Damage caused by accidents, or natural disasters, including but not limited to, fire, flood, and
wind.
6.
Damage caused by abuse, misuse, alteration, modification, or negligence.
7.
Any labor costs or travel, room and board expenses associated with the repair and/or
restoration of lost or damaged hardware, software or data.
EXCEPT AS EXPRESSLY PROVIDED IN THIS POLICY, XPC SHALL NOT BE LIABLE FOR ANY DAMAGES
WHATSOEVER, INCLUDING, BUT NOT LIMITED TO, DIRECT, INDIRECT, SPECIAL, INCIDENTAL,
CONSEQUENTIAL, OR MULTIPLE DAMAGES ARISING OUT OF THE USE OF THE PRODUCT OR
DAMAGE TO THE CONNECTED EQUIPMENT, REGARDLESS OF THE LEGAL THEORY ON WHICH
SUCH CLAIM IS BASED, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. SUCH DAMAGES
INCLUDE, BUT ARE NOT LIMITED TO, LOSS OF PROFITS, LOSS OF SAVINGS OR REVENUE, LOSS OF
USE OF THE PRODUCT OR THE CONNECTED EQUIPMENT OR ANY ASSOCIATED EQUIPMENT, LOSS
OF SOFTWARE, COST OF CAPITAL, COST OF ANY SUBSTITUTE EQUIPMENT, FACILITIES OR
SERVICES, DOWNTIME,
Xtreme Power Conversion® (XPC) Corporation 16
V2
Need help?
Do you have a question about the S70 Line?Interactive and is the answer not in the manual?