Download Print this page

HP 10504 Installation Manual: Powering On The Switch

10500 switch series.
Hide thumbs

Advertisement

Figure 35 Setting terminal emulation in Switch Properties dialog box

Powering on the switch

Before powering on the switch, verify the following items:
You know where the emergency power-off switch for the equipment room is located.
The switch has been securely mounted.
All the cards have been correctly installed.
The unused slots have been installed with blank filler panels.
All the network cables, fibers, power cords, and grounding cables have been correctly connected.
The input power voltage meets the requirement of the switch.
The console cable is correctly connected.
The terminal or PC used for configuration has started, and its configuration parameters have been
set.
To power on the switch:
Turn on the power source of the switch to power on the switch.
The following is sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare.
The Extend BootWare is self-decompressing...................................
.....Done!
40

Advertisement

Troubleshooting

This manual also for:

10508-v, 10508, 10512

Comments to this Manuals

Symbols: 0
Latest comments: