Configuring The Switch - HP 10504 Installation Manual

****************************************************************************
*
*
*
****************************************************************************
Compiled Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
BASIC CPLD Version
EXTEND CPLD Version : 0.0
PCB Version
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Starting to get the main application file--flash:/ 10500.bin!................
.........................................................................
The main application file is self-decompressing.............................
............................................................................
..Done!
System application is starting...
Starting to get the main application file--flash:/ 10500.bin!................
..........................................................................
The main application file is self-decompressing.............................
............................................................................
............................................................................
.....Done!
System application is starting...
User interface aux0 is available.
Press ENTER to get started.
Press Enter at the prompt. When the prompt
After powering on the switch, verify the following items:
• The cooling system is operating, and you can hear fan rotating noise and feel air being blown out.
The system status LEDs on the MPUs show that the system is operating correctly. For more
•
information about LED behaviors, see

Configuring the switch

By default, the switch does not authenticate the console login user at an AUX interface. To increase
system security and enable remote management:
BootWare, Version 1.00
: Jul 1 2010
: XLS408
: 32KB
: 1000MHz
: DDR2 SDRAM
: 1024MB
: 533MHz
: 508KB
: 128MB
: 0.0
: Ver.A
<Sysname>
"Appendix C
41
appears, you can configure the switch.
LEDs."
*
*
*