HP 10504 Installation Manual page 15

To ensure rack stability, install the slide rails to the lowest possible position when installing a single
•
switch on the rack. To install multiple switches on the rack, mount the heaviest switch at the bottom
of the rack.
• Identify the chassis and slide rail positions for the switch. For the height and other specifications, see
"Appendix A Chassis views and technical
Slide rail installation varies by rack type. This section uses the slide rails in the HP rack mounting kit
(JC665A) as an example.
To install a slide rail:
1. Read the mark on the slide rail (see
Figure 3 Right slide rail
(1) Mark
Table 7 Description for marks on the slide rails
Mark
F/L
F/R
2. Mark the position on the rack for installing the slide rail:
a. Make sure the bottom edge of the slide rail aligns with the middle of the narrower metal area
between holes, as shown in
b. Each rack post requires six screws to attach the slide rail. Mark the uppermost square hole and
lowermost square hole for installation.
c. Mark the square holes at the same height on the other three rack posts.
Table
(2) Guide rail
Description
Front end of the left slide rail
Front end of the right slide rail
Figure 4.
9
specifications."
7) to avoid making a mistake.
Remarks
Mount this end to the front left rack post.
Mount this end to the front right rack post.
(3) Installation hole